The tablet, as a product, according to state standards, should be supplied with a protective film pasted on the screen. The role of this film is clear: it protects the monitor from debris, dust, grease and mechanical damage. But over time, with active use, this film becomes unusable: air bubbles inevitably drive under it, causing distortion of the perception of what is happening on the screen and interfering with the passage of the signal. In addition, many developers put ads on the film, also interferes. In any case, sooner or later, the protective coating will have to be changed.
How to properly glue the protective film
Of course, there are users who refuse protection, and calmly run their fingers across a bare screen. But then the monitor will quickly use up its resource.
If a person has never before glued a new film to the screen of his tablet, and decided to do this on his own, he risks ruining the new coating and the screen itself.
Reference! Without proper skills, it is almost impossible to stick a barrier sheet - it is imperative that garbage pieces, dirt, and air bubbles get inside. Repeated gluing and subsequent peeling of the film from the display will significantly reduce its service life.
First of all, you should pay attention to what you are buying. Cheap products will not force to spread a large amount on the counter, but also serve much less frequently. Of course, you don’t need to go to extremes and buy something super advanced by a million per square decimeter - quality also has its limits. The best will be to choose something average, not outstanding anything. It is desirable to choose a film, the manufacturer of which corresponds to the manufacturer of the tablet. If this is not, then the universal, or "alien" is also suitable.
Acquired product is strictly recommended to cut the shape of the window of the tablet. The procedure itself is best done in the bathroom (in the presence of hot water). The hot jet will attract dust particles to itself, and this will save the screen from unnecessary scratches. Make sure that the spray does not fall on the gadget - all electronic devices are afraid of moisture.
If the tablet was used in the absence of a film, then before applying it is necessary to wipe the display to rid it of greasy stains and microscopic specks. How and what to wipe is written below in the appropriate section. The tablet should lie flat. Any solid, but not sharp, flat object in the shape of a thin rectangle will serve as a tool - a bank card will work perfectly.
The film comes with a second layer that protects the adhesive side from drying out. This second layer needs to be peeled off, and, as soon as possible, so that nothing of the air can adhere to it, but at the same time it is extremely neat to glue the corners to the screen on the upper part. Now with one hand (if there is an opportunity to do this together - with two hands) you need to hold the bottom, not glued corners, and gradually apply the coating on the display, smoothing it with a flat object. Movement should be performed left-right, gradually moving to the bottom. If you approach the process with enough patience and accuracy, then the film will fall well.
How to wipe the screen
Water or wetter wipes for such procedures will not work. Special formulations, which are sold in equipment maintenance stores, save from greasy stains. Often these forms have the form of a spray. Spray should be applied on a napkin, and it, in turn, is wiping the screen. Strong pressure on it is not necessary - the composition cracks down on harmful substances through simple contact.
Dumps are removed with paper tape. It needs to be glued, and then tear off immediately. The adhesive surface will take all the trash with you.
If the glass of the tablet turned out to be damaged so badly that cracks formed on it, then it is senseless to try to glue the fragments - the monitors of all modern devices, even those not equipped with sensors, contain a liquid that spills when it breaks. The display can be replaced in the service center.
Leave Your Comment