DIY PVC boat table

Each fisherman with a boat in his arsenal strives to further improve his capabilities. For example, you can make a table, which will be very convenient. It can accommodate not only fishing gear, but also other necessary things. You can make a table for a PVC boat with your own hands using plywood or other suitable materials.

Necessary materials

In order to make a simple design of the table, it is necessary to prepare some materials:

  • Plywood or any other material that you could pick up. When it comes to plywood, its thickness should be about 1 cm.
  • For fastening, use self-tapping screws 30-45 mm.

Tools that most likely are in the arsenal of every home master.

REFERENCE. To make the most convenient table for your boat, you can use ready-made drawings or create a drawing according to individual parameters. This can be an additional holder for spinning rods, cans, as well as supports for other fishing tackle that the angler needs.

Do-it-yourself simple design

If you decide to make such a product for yourself, you will surely take responsibility for the work. Take a sheet of plywood 1 cm thick.

REFERENCE. If you have certain skills, you can assemble this design in just 1 hour. Agree, this is very fast, because the manufacturing process is extremely simple.

The manufacturing algorithm is as follows:

  1. You need to cut four parts from plywood. Transfer dimensions from the drawing that you prepared in advance.
  2. Apply a circle with a radius of 19 cm to the workpiece, provided that the diameter of the balloon is 38 cm.
  3. Cut the part according to the applied contour. Attach it to the tank of your boat, make a kind of fitting.
  4. Perform two parts that are the same with each other. Please note that a battery will be installed inside them later.
  5. Connect the two shelves together, as well as the battery. Use previously prepared fasteners.
  6. On top of the fabricated structure, it is worth making recesses. This is important to do. So that in the future you have the opportunity to hide all the wiring in them, and this is important at least for your comfort.
  7. Recess at the top of the product. Their purpose is to move the structure along the length of your boat.
  8. Make a hole in the center, thanks to which you can fix the stand for the fish finder.
  9. Install the assembly of your own construction.

That's the whole fairly simple process of making a table on your own.

REFERENCE. Such a structure would be better to install closer to the seat, it will be more convenient to use.

Watch the video: DIY PVC Bait & Outdoors Cutting Board (March 2024).

Leave Your Comment